
Residential HVAC Service Memberships

HVAC
- Comprehensive annual safety inspection
- Annual furnace and AC system tune-up including up to 1″ air filter replacement
- 100% of membership fees applied to furnace & AC replacement up to $1,000
- Visual inspection of ductwork

Electrical
- Free initial electrical inspection
- Includes inspection of main breaker, ground connections, all outlets, and more!
Plumbing
- Comprehensive annual inspection
- Annual water quality analysis

15% OFF Repairs, Accessories, Tanked Water Heaters & water softeners
(Does not apply to purchase/installation of new equipment or fixtures other than tanked water heaters)
$27 / Month
Membership plans automatically renew on a monthly basis. A minimum commitment of one year is required before cancellation is allowed. Membership requires automatic monthly payments via credit or debit card.

- Check & replace filter (1″)
- Check thermostat & replace battery as needed
- Inspect blower components
- Check airflow for proper efficiency
- Check safety controls
- Check and clean condensate drain
- Visual inspection of ductwork
- Inspect & clean outdoor condenser coil
- Inspect contactor
- Check start & run capacitors
- Measure temperature drop across the coil
- Inspect condensate system
- Inspect evaporator coil
- Check compressor amps & volts
- Inspect burners
- Clean flame sensor
- Check heat exchanger for defects
- Inspect pilot operations
- Check flue for proper vent operations
- Check ignition sequence, heat anticipator, & high limit
- Check for gas leaks at the furnace
- Measure temperature rise through furnace
- Oil blower motor (where necessary)
AC services, plus:
- Test defrost cycle operation
- Test reversing valve operation
- Test emergency heat operation
Gas heat services, plus:
- Check pump operation
- Check flue damper and flue
- Check roll-out switch, line setting, and pressure tank
- Check water pressure & temperature
- Check capacitor
- Inspect contactor
- Check compressor amps & volts
- Check suction/discharge, superheat
- Check loop pressure and pump operation
- Check heat of extraction and rejection
- Check indoor temperature entering and leaving
Gas heat services, plus:
- Replace oil nozzle
- Inspect burner & heat exchanger for defects
- Check ignitor & transformer connections
- Check oil burner motor
- Check draw on flue
